电流灵敏度:100 fA
SMU通道数量:4
电压范围:-8 V 至 8 V
最大直流吸收功率:24 瓦
PXIe,4通道,±8 V,3 A精密PXI源测量单元
ONETEST 欢迎您
厂商登录 | 入驻
登录 | 注册 购物车 微信公众号厂商登录
电流灵敏度:100 fA
SMU通道数量:4
电压范围:-8 V 至 8 V
最大直流吸收功率:24 瓦
PXIe,4通道,±8 V,3 A精密PXI源测量单元
以下指标取自 Teledyne 官方在线规格书,按原文档小节分组。
| 378264G-01 | October 2025 |
| 378264F-01 | May 2025 |
| 378264E-01 | May 2025 |
| 378264D-01 | August 2024 |
| 378264C-01 | June 2021 |
| 378264B-01 | June 2021 |
| 378264A-01 | April 2020 |
| CH <0..3> Output HI | HI force terminal connected to channel power stage (generates and/or dissipates power). Positive polarity is defined as voltage measured on HI > LO. |
| CH <0..3> Guard | Buffered output that follows the voltage of the HI force terminal. Used to drive shield conductors surrounding HI force and Sense HI conductors to minimize effects of leakage and capacitance on low level currents. |
| CH <0..3> Output LO | LO force terminal connected to channel power stage (generates and/or dissipates power). Positive polarity is defined as voltage measured on HI > LO. |
| CH <0..3> Sense HI | Voltage remote sense input terminals. Used to compensate for I*R voltage drops in cable leads, connectors, and switches. |
| NC | No Connect. |
| 1 V | 100 nV |
| 8 V | 1 µV |
| 1 μA | 100 fA |
| 10 μA | 1 pA |
| 100 μA | 10 pA |
| 1 mA | 100 pA |
| 10 mA | 1 nA |
| 100 mA | 10 nA |
| 3 A | 1 µA |
| Voltage mode, ≤4 V step, unloaded[14] | <50 μs, typical |
| Current mode, full-scale step, 3 A to 100 μA ranges[15] | <50 μs, typical |
| Current mode, full-scale step, 10 μA range[16] | <100 μs, typical |
| Current mode, full-scale step, 1 μA range[17] | <200 μs, typical |
| 3 A to 100 μA ranges | <40 μs, typical |
| 10 μA range | <100 μs, typical |
| 1 μA range | <200 μs, typical |
| Voltage accuracy | Add (10 ppm of voltage range + 25 μV) per volt of LO lead drop, plus 10 μV per volt of HI lead drop to voltage accuracy specification |
| Maximum sense lead resistance | 100 Ω |
| Maximum lead drop per lead | 1 V, maximum 8 V between HI and LO terminals |
| Voltage, local sense[18] | 100 μV/mA, nominal; 200 μV/mA, maximum |
| Voltage, remote sense | Error included in accuracy specifications |
| Current | Error included in accuracy specifications |
| Isolation voltage, any pin to earth ground[19] | 60 V DC, CAT I |
| Withstand voltage | 800 Vpk |
| Output HI | ±10 V |
| All other pins | ±60 V |
| Overcurrent or overvoltage | Automatic shutdown, output disconnect relay opens |
| Overtemperature | Automatic shutdown, output disconnect relay opens |
| Output impedance | 2 kΩ, nominal |
| Offset voltage | 1 mV, typical |
| 1 μA | 0 to ±4 MΩ |
| 10 μA | 0 to ±400 kΩ |
| 100 μA | 0 to ±40 kΩ |
| 1 mA | 0 to ±4 kΩ |
| 10 mA | 0 to ±400 Ω |
| 100 mA | 0 to ±40 Ω |
| 3 A | 0 to ±1.25 Ω |
| Available sample rates[21] | (1.8 MS/s)/N, nominal where N = 1, 2, 3, … 224 S is samples |
| Sample rate accuracy | Equal to PXIe_CLK100 accuracy, nominal |
| Maximum measure rate to host | 1.8 MS/s per channel, continuous, nominal |
| Maximum source update rate[22] | 100,000 updates/s, nominal |
| Source event delay | 10 µs, nominal |
| Source event jitter | 2 µspk-pk, nominal |
| Measure event jitter | 2 µspk-pk, nominal |
| Input trigger types | Start, Source, Sequence Advance, Measure |
| Polarity | Active high (not configurable) |
| Minimum pulse width | 100 ns |
| Polarity | Active high (not configurable) |
| Minimum pulse width | >200 ns |
| Output trigger types | Source Complete, Sequence Iteration Complete, Sequence Engine Done, Measure Complete |
| Polarity | Active high (not configurable) |
| Minimum pulse width | 230 ns |
| Dimensions | 3U, one-slot, PXI Express/CompactPCI Express module 2.0 cm × 13.0 cm × 21.6 cm (0.8 in. × 5.1 in. × 8.5 in.) |
| Weight | 448 g (15.8 oz) |
| Front panel connectors | 25-position D-SUB, male |
| +3.3 V | 1 A, typical |
| +12 V | 1.3 A, typical at idle; 6 A, maximum at full load |
| Operating temperature | 0 °C to 55 °C [23] |
| Storage temperature | -40 °C to 71 °C |
| Operating humidity | 10% to 90%, noncondensing[24] |
| Storage humidity | 5% to 95%, noncondensing |
| Pollution Degree | 2 |
| Maximum altitude | 2,000 m (800 mbar) (at 25 °C ambient temperature) |
| Channels | 0 through 3[25] |
| DC voltage ranges | 1 V, 8 V |
| DC current ranges | 1 µA, 10 µA, 100 µA, 1 mA, 10 mA, 100 mA, 3 A |
| Sourcing[26], all chassis | 24 W per channel and 40 W total |
| ≥58 W slot cooling capacity chassis[27] | 24 W per channel and 40 W total |
| <58 W slot cooling capacity chassis | 15 W per channel and 15 W total |
官方规格书:https://www.ni.com/docs/en-US/bundle/pxie-4147-specs/page/specs.html
NI官方渠道
官方渠道(官网 / 热线 / 邮箱)
官方渠道(中国大陆)
• 官网 www.ni.com/zh-cn
• 在线选购 www.ni.com/zh-cn/shop.html
• 经销商查询
官网「查找经销商」 www.ni.com/zh-cn/shop/advisors.html
• 联系方式
NI 中文官网不公布中国区电话与邮箱,报价、技术支持、校准、维修一律通过官网在线表单提交(「联系我们」页)
全国办事处
公司总部
• NI(National Instruments)
• 地址
11500 N Mopac Expwy, Austin, TX 78759-3504, United States
• 母公司
Emerson(2023 年完成收购,NI 隶属艾默生测试与测量业务集团)
0条提问
X
提问
X
回答
发表口碑
AI问答